How to program a Vauxhall Vivaro Key Fob?

I am planing on buying a new key %26amp; fob for my Vauxhall Vivaro and was wondering if i could program it myself for the van or do I have to take it to a specialist? And if i can how do i do it????





Thanks


Brendan|||I think it's just the same as the Renault Master on which it's based.





1. Turn Ignition OFF.


2. Press the central door locking button for more than 5 seconds.


Note : the door should lock then unlock.


3. When this happens, 10 seconds is allowed for the rest of the procedure and the immobiliser warning light should illuminate 鈥?not flash, illuminate.


4. Press the remote control once, the doors should lock and unlock.


5. Repeat for second remote if required.


6. Check that the remote control unlocks and locks the doors.





if no joy-





Disconnect Negative Terminal of battery for over 15 min , reconnect battery.





Hold down the internal central locking button for 5 seconds the main red light will go to solid red.


Press the internal central locking button twice.





Then holding the key fob button insert into ignition (still holding the button) and turn to the pre ignition position where the glow plugs light lights up|||It's not a DIY job. You actually have to set the car's electronics to recognise the new key fob. Vauxhall dealer or a GOOD general auto electrical specialist. You will need the car's PIN; this is a four digit number that should have been supplied on a card with the car. If you haven't got this it's rather expensive.|||Yes you need to go to a dealer and the code for the Vivaro is actually something like a 17 digit code.|||you will have to get vauxhall to do it or try an auto locksmith